Memory; Ddr3-Sdram Dimms - HP RP3 Maintenance And Service Manual

Memory

Description
8-GB, PC3-12800
4-GB, PC3-12800
2-GB, PC3-12800
The computer comes with one double data rate 3 synchronous dynamic random access memory
(DDR3-SDRAM) small outline dual inline memory module (SODIMM).

DDR3-SDRAM DIMMs

CAUTION:
processor is not compatible with DDR3U memory and if you plug DDR3U memory into the system
board, it can cause the physical damage to the SODIMM or invoke system malfunction.
For proper system operation, the SODIMM must be:
●
industry-standard 204-pin
●
unbuffered non-ECC PC3-12800 DDR3-1600 MHz-compliant
●
1.5 volt DDR3-SDRAM SODIMMs
The DDR3-SDRAM SODIMM must also:
●
support CAS latency 11 DDR3 1600 MHz (11-11-11 timing)
●
contain the mandatory Joint Electronic Device Engineering Council (JEDEC) specification
In addition, the computer supports:
●
512-Mbit, 1-Gbit, and 2-Gbit non-ECC memory technologies
●
single-sided and double-sided SODIMMS
●
SODIMMs constructed with x8 and x16 devices; SODIMMs constructed with x4 SDRAM are not
supported
NOTE: The system will not operate properly if you install an unsupported SODIMM.
20 Chapter 4 Removal and Replacement Procedures
This product DOES NOT support DDR3 Ultra Low Voltage (DDR3U) memory. The
Spare part number
689374-001
689373-001
689372-001