Fujitsu MAP3147 Scsi Logical Interface Specifications page 241

C* Q* Name
13 00 Sync Byte not found for
Data field
14 00 Record entity not found
01 Record not found
15 01 Mechanical positioning
Error
02 Positioning Error detected
by read of medium
17 01 Recovered data with retries A data error was recovered from by reading was retried.
02 Recovered data with
positive head offset
03 Recovered data with
negative head offset
06 Recovered data without
ECC: data auto-
reallocated
08 Recovered data without
ECC: recommended
rewrite
19 02 Defect list error in primary
list
03 Defect list error in grown list An error was detected during reading of the defect list (G List).
80 Log information read error
81 Log information write
error
82 Drive Parameter SA read
Error
83 Drive Parameter SA write
Error
84 Mode Select SA write
Error
1A 00 Parameter list length error There is a mistake in the indication of the parameter list page length.
1C 01 Primary defect list not found The defect list (P List) header is incorrect.
02 Grown defect list not found The defect list (G List) header is incorrect.
90 SA information list not
found
1D 00 Miscompare during verify
operation
80 Miscompare during self-
configuration
* C: Sense Code, Q: Sub-sense Code
C141-E167
Table 5.2 Sense and subsense codes (2 of 5)
SB (Sync Byte) could not be detected in the Data area.
Expected data from a sector was undetected. (LBA compare error
detected by FMT)
The target data block (sector) could not be detected.
A seek error occurred in the drive.
LBA did not match due to Cylinder number's mismatch.
A data error was recovered by read retry with offsetting head to
positive direction.
A data error was recovered by read retry with offsetting head to
negative direction.
Automatic alternate allocation was applied without ECC correcting a
data error.
Rewriting to the same sector was performed without ECC correcting
a data error.
An error was detected during reading of the defect list (P List).
An error was detected during reading of statistical information.
A write error was detected during writing of statistical information.
An error was detected during reading of SA information (Device
Information)
An error was detected during writing of SA information (Device
Information)
An error was detected during writing of SA information (Mode
Select Paramenter)
The SA information (MODE SELECT parameter) header is
incorrect.
Comparison of data transferred from the INIT by a VERIFY
command (when the Byte Check mode was specified) with data read
from the disk media was terminated unsuccessfully.
There is an unmatch to compare read data with write data during
self-configuration.
Explanation
5.1 Sense Data
Sense
key
1, 3, B
1, 3, B
3, B
1, 3, B
1, 3, B
1
1
1
1
1
3
3
3
3
3
3
3
5
3
3
3
E
E
5 - 7