Fujitsu MAP3147 Scsi Logical Interface Specifications page 249

K* C* Q*
3 11 xx Unrecovered read error
13 00 Sync byte not found for data field
14 01 No record found
These errors were detected during accessing of the
disk media, but they were errors which could not
be recovered from through the IDD's retry
processing.
3 15 xx Positioning error
This is an error of the disk drive's seek system
3 19 xx SA information error
1C xx SA information error not found
The information recorded in (SA) on the disk
media cannot be read correctly.
3 31 00 Medium form at corrupted
31 01 FORMAT command failed
The data format on the disk media is not correct.
4 03 xx Peripheral device write fault
32 01 Defect list update failure
These are errors detected in the operation of the
disk drive.
4 15 xx Positioning error
This is an error of the disk drive's seek system.
4 32 00 No defect spare location available
No usable alternate blocks exist on the disk drive.
4 40 nn Diagnostic failure on component 'nn'
An error was detected in the IDD's self-diagnosis.
4 44 nn Internal target failure
An internal hardware error or a microcode
detection error was detected in the IDD.
4 4C xx Calibration failed
C4 xx Drive failure
The initial seek was terminated abnormally. Or, a
serious error was detected in the drive's control
system.
* K: Sense Key
Q: Sub-sense code
C141-E167
Table 5.3 Sense data error classification (2 of 4)
Outline of Error
C: Sense Code
L: Logging Necessary? (shown in Section 5.2.3)
5.2 INIT Error Recovery Methods (Recommended)
Need
Need
Need
Need
Need
Need
None
Need
Need
Need
Recovery Method
L*
(See Table 4.4.)
12
12
7
18
7
12
19
13
20
10
5 - 15