Fujitsu MAP3147 Scsi Logical Interface Specifications page 242

Sense Data Error Recovery Methods
Name
C* Q*
1F 00 Partial Defect List Transfer Read Defect Data command (37h) cannot transfer all the Defect data
20 00 Invalid command
operation code
21 00 Logical block address out
of range
24 00 Invalid field in CDB
25 00 Logical unit not supported An illegal LUN was specified.
26 00 Invalid field in parameter
list
04 Invalid Release of
Persistent Reservation
27 00 Write protected
29 01 Power on occurred
02 SCSI reset occurred
03 TARGET RESET message
occurred
05 Transciever mode changed
to Single-Ended
06 Transciever mode changed
to LVD
2A 01 Mode parameter changed
03 Reservations preempted
04 Reservations released
05 Registrations preempted
2F 00 Command cleared by
another INIT
31 00 Medium format corrupted The media format is different from the original format. (The media
01 FORMAT command failed For some reason, formatting cannot be completed and reformatting
32 00 No defect spare location
available
01 Defect list update failure
37 00 Rounded parameter
* C: Sense Code, Q: Sub-sense Code
5 - 8
Table 5.2 Sense and subsense codes (3 of 5)
in the target because the numbers of defect exceeded the maximum.
CDB byte 0 (operation code) is illegal.
A logical block address which exceeds the drive's maximum value
was specified.
There is an error in a specification in the CDB.
There is an error in the parameter list specifications transferred from
the INIT during command execution.
There is unmatched valid reservation status in the parameter list
specifications
A write operation was attempted in a write protected area. Or a
write operation is prohibited at the external operation panel.
Power On occurred.
A SCSI RESET was received.
A TARGET RESET message was received.
Transciever mode was changed to Single-Ended mode.
Transiever mode was changed to LVD mode.
The MODE SELECT parameter values were changed by another INIT.
A persistent reserve state was cleared by another INIT.
A persistent reserve state was released
A persistent reserve state was prempted by another INIT.
A command was forcibly terminated by another INIT during
execution or queuing.
• By a CLEAR QUEUE message
• The sense hold state was entered when the QErr bit was set on "1."
• The DQue bit was changed from "0" to "1."
was not formatted after the data format specification was changed by
the MODE SELECT command.)
is necessary.
No usable alternate block area exists. Or alternate block processing
cannot be performed due to control table overflow.
Updating of the defect list (G List) failed.
Rounding processing of the MODE SELECT parameter specified by
the command was performed.
Explanation
Sense
key
1
5
5
5
5
5
5
7
6
6
6
6
6
6
6
6
6
6
3
3
4
4
1
C141-E167