Fujitsu MAP3147 Scsi Logical Interface Specifications page 250

Sense Data Error Recovery Methods
K* C* Q*
5 20 00 Invalid command operation code
21 00 Logical block address out of range
24 00 Invalid field in CDB
25 00 Logical unit not supported
26 00 Invalid field in parameter list
There is an error in the command specification
contents.
5 3D 00 Invalid bits in IDENTIFY message
90 00 Initiator's SCSI ID not identified
An error was detected in the SCSI protocol in the
command execution sequence.
6 29 xx Power on, reset, or BUS DEVICE RESET occurred
The IDD was initialized by a Power on, RESET
condition or BUS DEVICE RESET message.
6 2A 01 Mode parameters changed
The MODE SELECT parameters were changed by
another INIT.
6 2F 00 Commands cleared by another INIT
Commands were cleared by another INIT.
6 3F 01 Microcode has been changed
02 Changed operation definition
6 5B 01 Log exception (Threshold condition met)
The current cumulative value exceeded the current
threshold value.
02 Log count at maximum
The current cumulative value reached the
maximum value.
6 5C 01 Spindle synchronized
Rotational synchronization was completed.
6 5C 02 Spindle not synchronized
Rotational synchronization deviated.
7 27 00 Write protected
Access to a read protected or write protected.
7 2C 00 Command sequence error
The SET LIMITS command was issued 2 times
within a group of commands linked in a series.
* K: Sense Key
Q: Sub-sense code
5 - 16
Table 5.3 Sense data error classification (3 of 4)
Outline of Error
C: Sense Code
L: Logging Necessary? (shown in Section 5.2.3)
Recovery Method
L*
(See Table 4.4.)
None 2
None 3
None 14
None 21
None 25
None 27
None 26
None 22
None 23
None 15
None 2
C141-E167