Fujitsu MAP3147 Scsi Logical Interface Specifications page 244

Sense Data Error Recovery Methods
C* Q* Name
45 00 Select/Reselect failure
47 00 SCSI parity error
48 00 INITIATOR DETECTED
ERROR message received
49 00 Invalid message error
4C nn Logical unit failed self-
configuration
4D nn Tagged overlapped
command
4E 00 Overlapped commands
attempted
55 04 Insufficient Registration
Resource
5C 01 Spindle synchronized
02 Spindle not synchronized. Rotational synchronization deviated.
5D nn SMART predictive failure SMART related sense data
90 00 Initiator's SCSI ID not
identified
C4 nn Drive Failure
* C: Sense Code, Q: Sub-sense Code
5 - 10
Table 5.2 Sense and subsense codes (5 of 5)
A response wait time-out from the INIT was detected in the
RESELECTION phase.
A parity error was detected on the SCSI data bus.
The INITIATOR DETECTED ERROR message was received from
the INIT.
An unsupported or inappropriate message was received.
The IDD's initial setup failed. ('nn' is a Fujitsu unique code)
• A1: SA Read error (any 3/11/** error during SA read)
• A3: SA Read error (any 3/13/** error during SA read)
• A4: SA Read error (any 3/14/** error during SA read)
• A5: SA Read error (any 3/15/** error during SA read)
• A7: SA Read error (any 4/44/** error during SA read)
• A8: Invalid SA (Header/Check Sum)
• E0: Initial calibration failed
Before completing one command execution, new command having
the same tag number was issued to the same logical unit. (nn=queue
tag number)
1) Before execution of an untagged command was completed, the
same INIT issued a new command to the same LUN.
2) Before execution of a tagged command was completed, the same
INIT issued a command to the same LUN with the same tag. Or,
an untagged command was issued when not in the sense hold
state.
PERSISTENT RESERVATION OUT command is issued from
insufficient device server resource.
The rotational synchronization operation was completed.
12: The read error rate attribute has reached the failure threshold.
14: The frequency of grown defect allocation attribute has
reached the failure threshold.
43: The seek error rate attribute has reached the failure threshold.
56: The spin up time attribute has reached the failure threshold.
64: The remaining alternate sector count attribute has reached the
failure threshold.
FF: The drive is in test mode.
Since the SCSI ID of the INIT was not notified in the SELECTION
phase, the RESERVE, RESERVE EXTENDED, RELEASE AND
RELEASE EXTENDED commands cannot be executed.
A serious error was detected in the drive's control system. ('nn' is a
Fujitsu unique code)
00: Abnormal Rotation of Spindle Motor
01: Any error at Spindle Motor Start
30: On track failure
Explanation
Sense
key
B
B
B
B
4
B
B
5
6
6
0, 1, 6
5
4
C141-E167