Command Id Character (Hex) Start/Stop Buffer Hex Dump - Epson C82314* User Manual

COMMAND 41: COMMAND ID CHARACTER
Specifies the character which can be used for the command identifier (in place
of "Z" which follows the ' Lead In' characters.
VALUE DESCRIPTION
*5A
ZZ
NOTE: The character selected must not be 0 through 9 or A through F (valid
hex values), or L, P, U.
EXAMPLE: &%Z41,59
COMMAND 42: START AND STOP BUFFER HEX DUMP
Upon receipt of a start command, the coax interface, starting with the next
buffer received, sends all host data directly to the printer as hexadecimal
printing until a stop command is received or the printer is powered off.
VALUE DESCRIPTION
* 0
1
2
NOTES: This is an alternative to pressing both push buttons on the interface
card and holding them for more than 2 seconds to activate Buffer Hex
Dump.
This command enables the user to print only the section of the
document that is in question in Buffer Hex Dump Format. But, hex
printing starts with the buffer following the start command and stops
with the buffer following the stop command.
EXAMPLES: &%Z42,1
&%Z42,2
Makes Z the command character.
ZZ is the ASCII HEX value of the command ID character.
Specifies ' Y' as the alternate command ID character
No Action Taken
Start Buffer Hex Dump
Stop Buffer Hex Dump
Starts Buffer Hex Dump Printing
Stops Buffer Hex Dump Printing
A-17