Macintosh System Requirements - Epson 10600 Printer Manual

4 | Introduction
Note
If you are not using Photo
Printing Accelerator in
your driver (see page 1-33
for details), or if you are
using a software or
hardware RIP, you must
have a Power Macintosh
G4 with a 500 MHz or
higher processor and
512MB RAM to keep the
printer running at full
engine speed.
For optimum
performance, we
recommend the latest
Macintosh system
available with a
FireWire connection.
If you are running System
8.5.1 on an iMac, Apple
recommends that you
download iMac Update
1.1 from their web site.

Macintosh System Requirements

To use your printer in either a standalone or peer-to-peer network
environment, your system should include the requirements listed below:
For USB connection: Power Macintosh
•
(System 8.5.1 through 9.x; System 9.2.2 or later recommended)
For IEEE 1394 connection: iMac DV, G3, or G4 series (System 8.6 or
later with FireWire
For 10/100 BaseT Ethernet connection: iMac, G3, or G4 series (System
8.5.1 through 9.x; 9.2.2 or later recommended)
350 MHz processor (700 MHz or higher recommended)
•
256MB of RAM (at least 512MB recommended)
•
At least 8GB available hard disk space to install the software and process
•
files (60GB or more recommended)
Quad-speed (4×) or faster CD-ROM or DVD drive for installing the
•
printer software
For USB connection: a compliant USB port and a shielded USB "AB"
•
cable from Series A (computer) to Series B (printer), up to 6.6 ft
(2 meters) long
For IEEE 1394 (FireWire) connection: a compliant IEEE 1394 port
and a shielded IEEE 1394 cable
For network connection: an RJ-45 Ethernet cable
®
®
Update 2.1 or later)
4
G3, G4, or iMac ™ series