Epson 10600 Printer Manual page 160

Error messages (continued)
Message Light
FRONT COVER Pause light on
OPEN
INK COVER OPEN Pause light on
LOAD ROLL Paper Out
PAPER light on
LOAD SHEET
PAPER
PAPER JAM Paper Out
light flashing
PAPER NOT CUT Paper Out
light flashing
PAPER NOT Paper Out
STRAIGHT light flashing
PAPER OUT Paper Out
light on
RELOAD PAPER Paper Out
light on
Explanation
Lower cover is open.
You are replacing the
ink cartridge(s) and the
ink compartment cover
is open.
Paper source setting in
printer software is
different from control
panel.
Paper has jammed in
the printer.
Roll paper was not cut
completely.
Cut paper did not fall
off.
Paper slipped and fed
into the printer at an
angle.
No paper is loaded.
Paper ran out.
Paper could not be
reversed into the
printing position.
Image is too wide for
the paper loaded in the
printer.
Paper is not fully
ejected.
PAPER NOT CUT error
was cleared.
6-3
Resolving Problems
Response
Close the lower cover.
Close the ink compartment cover when you are
finished replacing the ink cartridge(s).
Make sure the right paper is loaded and the
paper source setting is the same on the control
panel and printer software.
Remove the jammed paper. See page 6-13 for
more information.
Cut the paper manually, then remove the cut
paper from the printer. Reload paper, as
described on page 1-16.
Remove the cut paper from the printer. Reload
paper.
Reload paper, making sure the edges are
straight and aligned with the vertical row of
holes at the paper exit.
Load paper.
Remove any printouts or paper remaining in the
printer and load more paper.
If the message appears during a print job, reset
the printer by pressing the Pause button for 3
seconds. Then load paper and resend the job.
Remove the paper. Reload it so that the bottom
edge is straight and aligned with the vertical
row of holes at the paper exit.
Resize your image or load wider paper.
Cut the paper at the paper insertion slot, then
reload paper.
Reload paper.
| 6-3