Hitachi XP P9500 User Manual page 103

For details on the commands, refer to the Solaris 10 documentation.
Table 3-18 Support for the Solaris zones on page 3-39
support for the Solaris zones.
Table 3-18 Support for the Solaris zones
Item
Installing HDLM
Path operations
Displaying path
statuses
Accessing HDLM
devices
Uninstalling HDLM
• When performing a new installation or upgrade installation of HDLM using
the pkgadd command, respond as follows when the message output by
the pkgadd command prompts you to enter information:
When you want to continue the installation, respond to all prompts by
¢
entering y.
When you want to interrupt or stop the installation, respond by
¢
entering q.
• Before you perform the following operations in an environment whose run
level is less than 2, execute the procedure described in
When the Host Is Started in Single-User Mode on page 4-4
in Single-User Mode on page
Installing HDLM
¢
Configuring a boot disk environment
¢
Setting up HDLM functions
¢
Setting up an integrated trace
¢
Creating a file system
¢
Executing an HDLM command
¢
Using an HDLM device
¢
Changing the configuration of the HDLM operating environment
¢
Applying an HDLM service pack
¢
#
In single-user mode, HDLM command activity is not logged to
integrated trace files.
• When you install HDLM while the 32-bit kernel mode is being used, only
the 32-bit version of HDLM will be installed. When you install HDLM while
the 64-bit kernel mode is being used, both the 32-bit and 64-bit versions
of HDLM will be installed. Before installing HDLM, decide which kernel
mode you will use to operate Solaris and, if needed, change to the
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
Global zone Non-global zone
Supported Not supported
Supported Not supported
Supported Not supported
Supported Supported
Supported Not supported
4-4:
#
shows the HDLM
Remarks
--
--
--
The devices must
be allocated to the
relevant zone.
--
Initializing HDLM
in Operation
3-39