b: The number of paths for each HDLM device
c: The I/O timeout value for the sd or ssd driver
d: The total number of all HDLM devices
#1
#2
Uninstalling HDLM
This section explains how to return the HDLM environment to the way it was
before HDLM was installed, and describes each step of the process.
Overview of HDLM Uninstallation
Return the HDLM environment to the way it was before HDLM was installed
by following the flow shown below in
uninstallation on page
#
Perform as required.
3-164
If the number of paths differs depending on an HDLM device, use the
maximum number for the calculation.
The I/O timeout value used for sending a notification to the sd or ssd
driver depends on the timeout settings for switches or HBAs.
3-164.
Figure 3-30 Overview of HDLM uninstallation
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
#1
#2
Figure 3-30 Overview of HDLM