Hitachi XP P9500 User Manual page 164

After editing
16 Edit the post-migration boot disk's /etc/dumpadm.conf file, changing the
.
dump device definition in the DUMPADM_DEVICE parameter from the pre-
migration boot disk to the post-migration boot disk.
An example is shown below.
Before editing
After editing
17 Boot the system from the post-migration environment.
.
¢
¢
¢
18 Check the state database settings.
.
An example is shown below.
19 Add the post-migration boot disk to the SDS or SVM state database.
.
An example is shown below.
20 Delete the SDS or SVM state database replica that exists in the pre-
.
migration boot disk.
An example is shown below.
3-100
/dev/dsk/c0t0d0s1 - - swap - no -
DUMPADM_DEVICE=/dev/dsk/c8t50060E80004361D1d1s1
DUMPADM_DEVICE=/dev/dsk/c0t0d0s1
Skip to step 18 if SDS or SVM is being used and you are migrating a
replica of the SDS or SVM state database to the post-migration
environment. In this case, keep the pre-migration environment
recognized by Solaris.
Skip to step 21 if SDS or SVM is being used but you are not migrating
a replica of the SDS or SVM state database.
Skip to step 21 if SDS or SVM is not being used.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Solaris(R))