Hitachi XP P9500 User Manual page 272

To add a new LU:
1 Set up the storage system and switch so that Solaris recognizes the LU.
.
2 Check the LU newly recognized by the node.
.
You can check the LU by using the format command.
of executing the format command on page 4-26
executing the format command. The shaded portion represents the LU
newly recognized by the node.
3 If setup is performed for Quorum devices and disk device groups, on an
.
LU newly recognized by the node, release these settings.
When you unregister the SDS or SVM diskset, the diskset data will be
deleted so first back up any necessary data. For details on how to remove
settings for Quorum devices and VxVM disk groups, see
Cluster Settings on page 3-166
page
Remove SDS Settings on page 3-169
3-170
4 Make sure that the key used for disk reservation has been registered for
.
the LU newly recognized by the node.
Execute the following command on any node:
# /usr/cluster/lib/sc/scsi -c inkeys -d the-name-of-the-logical-
device-file-on-slice-2-of-the-LU-newly-recognized-by-the-node
The following shows an example of executing the command:
4-26
Figure 4-2 Example of executing the format command
3-165. For details on how to remove SDS or SVM disksets, see
of Preparations for HDLM Uninstallation on page
HDLM Operation
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
shows an example of
of Preparations for HDLM Uninstallation on
or Remove SVM Settings on page
Figure 4-2 Example
Remove Sun
3-165.