Table of Contents
Advertisement
PROBLEM GUIDE
PROBLEM
No power
Timer recording is not
)ossible.
RECmode cannot be
engaged.
Picture is poor on
playback.
Noise in picture on
playback
No picture on playback
Playback picture is partial-
ly noisy.
IV
program cannot be re-
corded or cannot be seen.
TV cannot be operated
from the remote, control.
The indication of the
VCR's display appeam
abnormal or no button can
be engaged,
THINGS
TO CHECK
•
Is power cord connected?
•
Is the program tlrQer set cor-
rectly?
•
Is the POWER switch set to
"OFF"?
•
Is the record safety tab missing?
•
Is the record safety tab missing?
•
Is the TV channel selector on
the proper channel?
•
Is the TV fine tuning set cor-
rectly?
•
Is video head clean?
•
Is the TV set to the proper
channel?
i
0 Is the TRACKING adjusted cor-
rectly ?
•
Is connection correct?
"! • Push the reset switch using s
toothpick, etc.
The display will be reset. Then
set the information again.
SOLUTION
• Connect power cord to AC
outlet.
•
Set the program timer cor-
rectly.
Q Set the POWER switch to
"OFF",
•
Place cellophane tape over
missing safety tab.
t
Place cellophane tape over
missing safety tab.
• On playback, the TV chan-
nel selector should be on
channel 3 or 4.
•
Fine tune your TV.
•
Head cleaning is necessary.
•
Set to correct channel, CH3
or 4. (for your video
channel}
• Press either TRACKING
control button (•
or •)
for
best picture.
• Connect correctly.
Fimt press TV button and
then press the button which
corresponds to the "IV func-
tion you went.
.....
_¥[
.....
• -"i--'__
=in m
n nl
/
NOTE: Mechanical sound Is slightly heard when the stop mode (with a cassette loaded In the VCR)
continues for more than 5 minutes. This does not Indicate a fault,
This means that the
tape protection mechanism in the VCR Is operating.
E39
Advertisement
Table of Contents
