Resetting The Nic; Restoring Factory Default Settings; Nic Status Lights - NEC 4400 - SuperScript Color Laser Printer User Manual

Resetting the NIC

If you change network settings, you may need to reset the
printer NIC for the new settings to take effect. To reset
1. Go to the URL Configuration Page, the URL is
http://<IP address>/configure.html.
2. Click on the Network Administration link. This displays
the Network Administration Page.
3. Click Reset in the System column,
or
• Turn the printer off and then on again.

Restoring Factory Default Settings

You can reset the NIC to its factory default settings. This
means that the NIC clears data such as names and IP
addresses. It does not lose its serial number or Network
Address. If you have changed the printer's name, it will
revert to its default name.
note:
You should restore factory defaults when the
printer is moved to a different network.
To reset the NIC to factory default settings
• Go to the Network Administration Page and click
Factory Defaults in the System column. You will need to
enter a password (the default is sysadm). Then turn the
printer off and on again. (The Network Administration
Page is described beginning on page 75, passwords are
explained on page 76.)
74 SuperScript 4400 Series — User's Guide

NIC Status Lights

When the NIC is installed, its two status lights, amber and
green, are located on the interface panel on the back of the
printer. Light patterns for normal operation are
Green light is on solid: This shows normal operation
while the printer is awaiting print jobs.
Amber light blinks continuously: This shows that the
NIC is receiving a print job.
Green light blinks 3 times and stays on: This occurs
when the printer has performed a successful self-test. It
then prints a Network Settings page.
Light patterns that identify error conditions are
described on page 112.