Placing 35-Mm Film Strips In The Holder; Printing Your Photos - Epson Stylus Photo RX640 series Basic Operation Manual

3. Close the document cover completely.
Continue with the steps in "Printing Your Photos" on
page 31 to scan and print your photos.
Placing 35-mm Film Strips in
the Holder
1. Open the film strip cover.
2. Slide your negative or positive film strip into the
holder, under the tabs.
Note:
The photos should be mirror-imaged when viewed from
overhead. (The shinier side faces down; the duller side faces
up.)
3. Close the film strip cover.
4. Fit the holder's tabs into the two small holes at the
front edge of the document table.
Top
Bottom
Make sure the film strip is in the middle of the
document table (not at the front edge) to align it
with the transparency unit window when you
close the cover.
transparency unit window
c
Caution:
Make sure you do not press too hard on the document table.
5. Close the document cover.
Continue with the steps in the next section to scan and
print your photos.

Printing Your Photos

Once you have placed your slides, negatives, or film
strips on the document table, you can view and select
the photos you want to print from the LCD screen. You
can choose from various sizes and types of Epson
paper.
1. Load the type of paper you want to print on (&
page 4).
Making Prints From Slides or Negatives
film strip is in the middle of
the document table
match the film mark on
the holder with the film
mark on the document
table
31