Making Prints From Your Mobile Phone; Printing Snapshots; Infrared Specification - Epson Stylus Photo RX640 series Basic Operation Manual

Making Prints From Your Mobile Phone

If your mobile phone has an infrared port, you can
send your JPEG photo data from your phone to the
EPSON STYLUS PHOTO RX and print it.

Printing Snapshots

Make sure your mobile phone allows you to send
photo data via infrared.
1. Load the type of paper you want to print on (&
page 4).
2. Press the q Setup button.
3. Use the u or d button to select PictBridge Setup,
then press the r button.
4. Use the LCD screen to select the print settings (&
page 17).
Make sure the Small Image setting is set to On,
as shown.
5. When you have finished selecting your print
settings, press OK.
6. Aim your phone's infrared port at the infrared
port on the EPSON STYLUS PHOTO RX and send
your photo data. See your mobile phone's manual
for details.
The EPSON STYLUS PHOTO RX starts printing
after it receives the data properly.
Note:
❏ The infrared port can receive data from up to 20 cm away.
❏ You can send up to 10 pieces of image data (the maximum total
image size is 3 M), including documents that are being printed.
❏ You may not be able to transmit your data if direct sunlight or
fluorescent light is shining onto either of the infrared ports.

Infrared Specification

Version Compliant to the IrDA
specifications. (Ver.1.3 Low Power)
Maximum data rate Up to 4 M bit/s
Minimum link 0.2 meters
distance upper limit
Making Prints From Your Mobile Phone
within 20 cm
®
Standard
37