Epson Stylus Photo RX640 series Basic Operation Manual page 33

11. Use the u or d button to select the setting item.
Then press OK to apply the new setting.
Setting Description
Paper Type Select the setting for the type of paper
you loaded (& page 4).
Paper Size Select the paper size you loaded.
Layout If you want to print without white borders
around the edges, choose Borderless.
Otherwise choose Border.
Quality Select the quality of the print to be made.
Borderless Adjust the margins that are trimmed
Expansion when you select Borderless.
Standard: No margins are printed.
Mid: The expansion rate is low. (The
margins might be printed.)
Min: The expansion rate is lower than
Mid. (The margins might be
printed.)
Filter Select B&W to print your photo in black
and white.
12. Press OK again, and then press the x Start button
to start printing.
If you need to cancel printing, press the
y Stop/Clear Settings button.
Restoring color in slides and
negatives
If you have slides or negatives that have become faded
over time, you can bring them back to life with Color
Restoration.
To restore color in faded slides or negatives, place your
slides or negatives on the document table as described
on page 30 or 31 and adjust the settings.
1. Press the t Slide/Negative button.
2. Select the film type.
If you are scanning slides, select Color
Positive(slide). If you are scanning a film strip,
select one of these options:
■
Color Negative (used in most cases)
■
BW Negative
■
Color Positive(strip)
Press OK after making your selection.
3. Make sure Color Restoration is set to On.
4. Continue from step 5 on page 32 to print from
slides, negatives, or film.
Cropping a photo
You can crop and enlarge photos when you print from
slides, negatives, or film. Before you start, place your
slides, negatives, or film on the document table as
described on page 30 or 31 and load the paper you
want to print on (& page 4).
1. Press the t Slide/Negative mode button.
Making Prints From Slides or Negatives
33