Sharp EC-12TWT9 Operation Manual page 10

REPLACEMENT INSTRUCTIONS
HOW TO REMOVE THE BOTTOM PLATE
Before replacing any parts, unplug the
vacuum cleaner from the electrical outlet. To
replace any of the following parts, set the
handle to the Parallel position.
Then turn the vacuum cleaner over, expos-
ing the underside.
Loosen the bottom plate by sliding the latch
away from the mounting screw. (Fig. 21)
Then remove the bottom plate.
I
Latch
/,oon,,oO
screw
Fig. 21
HOW TO REPLACE THE HEADLIGHT LAMP
1
2
3
(EC-14TWT6/14TAT6/12TWT6/
12TWT4/12TWT2 only)
i ii
4
Remove the headlight mounting screws..
(Fig. 22)
Note the arrangement of the lead wires and
then carefully lift out the headlight assem-
bly. (Fig. 23)
.Remove the lamp from the socket by push-
mg in gently and turning it counterclockwise.
(Fig. 23a)
Install the new lamp by pushing it gently
into the socket and turning clockwise. (Fig.
23b)
Use any standard bayonet base vacuum
cleaner lamp rated 125V, 20W.
® ®
Headlight mounting Screws
Headlight assembly
Fig. 22
Fig. 23a Fig. 23b
5 Reinsert the headlight assembly.
Secure it with the mounting screws.
10
Lamp Socket
i
Fig. 23