Replacement Instructions - Sharp EC-12TWT9 Operation Manual

REPLACEMENT ]INSTRUCTIONS
HOW TO REPLACE THE BELT
(EC-12TWT6/12TWT4/12TWT2/12TXT2/12SXT4Bonly)
1
2
3
4
5
6
After removing the bottom plate, lift up the belt
cover and remove the shelter plate. (Fig. 28)
Pull out the agitator and then remove the flat
belt from the motor shaft and the agitator pul-
ley.
Loop the new belt around the motor shaft and
then loop it around the agitator pulley. (Fig. 29)
Reinsert the agitator assembly, making sure
that both ends of the agitator assembly' fit in
the groove of the unit.
Be sure that the belt is not twisted and all
rotating parts move smoothly.
Install the shelter plate completely in the groove
with the marking of R side toward the belt
cover.("R" means "Rear".)
7 After reinstalling the shelter plate, close the
belt cover, then replace the bottom plate.
Belt cover
Fig. 28
Shelter plate
"R"mark
New belt
Fig. 29
HOW TO REPLACE THE BOTTOM PLATE
v_
When replacing the bottom plate, make
sure that all the parts are properly set
and the wires are not pinched.
1 Insert the front six tabs of the bottom
plate into the grooves at the front end of
the nozzle head, then reset the bottom
plate.(Fig. 30)
2
Fasten it by sliding the latch as shown.
(Fig. 31)
Grooves
Tabs
__tt__/ "ilatOm
I Latch -_ ,,
Bottom
Plate
Fig. 30
Fig. 31
12