Sharp EC-12TWT9 Operation Manual page 11

HOW TO REPLACE THE BELT
(EC-14TWT6/14TAT6 only)
F
When replacing the belt, always set the
RUG/FLOOR Selector to the "FLOOR" po-
sition.
1
2
After removing the bottom plate, lift up
the belt cover and remove the pulley
cover to determine if the belt is worn or
broken. (Fig. 24)
If the flat belt is worn or broken, pull out
the agitator and then remove the flat belt
from the motor shaft and the agitator pul-
ley.
Rat belt
Guide
ii
Belt cover
Moter
shaft
Flat
belt
3 Loop the new belt around the motor shaft
and then loop it around the idling pulley. Pulley cover Agitator assembly
(Fig. 25) Fig. 24
t
_" -... _,,#, , ,_,_ , Moter shaft
_"_,,_ _, Main pulley
L__... __- Idling pulley
Fig. 25
4 Then reinsert the agitator assembly, mak-
ing sure that both ends of the agitator
assembly are fitted into the groove of the
nozzle head. (Fig. 26)
Be sure to install the new flat belt into the
guide properly. (Fig. 24.)
Groove
Groove Agitator
assembly
Fig. 26
5 Be sure that the flat belt is not twisted and
all rotating parts move smoothly. (Fig. 27)
6 After reinstalling the pulley cover, close the
belt cover and replace the bottom plate.
Belt cover
Pulley cover
Fig. 27
11