Case A) Initial Configuration Using Remote Configuration With Step 7 / Ncm Pc - Siemens SIMATIC NET Manual

2.2.1 Case a) Initial configuration using remote configuration with
STEP 7 / NCM PC
The target PC station that is available online is configured directly with STEP7 /
NCM PC remote.
The advantage of this is that the project engineering data and the PC configuration
are consistent and the total effort is minimal. Address parameters are adopted
from the project engineering.
You can also transfer project engineering data to the PC station later by
downloading or loading the station (importing an XDB file).
Follow the steps below:
1. Select the PC station engineered in your STEP 7 project.
2. Select the menu command "PLC
Commissioning PC Stations - Manual and Quick Start
Release 5/2005
C79000-G8976-C156-07
How to Make the "Initial Configuration with an XDB File"
"
Configure" to open the "Configure: Zielrechner"
2 Getting Started "Configured Mode"
35