Siemens SIMATIC NET Manual page 40

2 Getting Started "Configured Mode"
4 In the properties dialog that opens, give the module an address.
In some cases, you can also set further module parameters, for example bus parameters,
(mandatory with PROFIBUS).
5 Repeat the steps for all other modules that exist in the local station and that you want to
operate in configured mode.
6 Using the "Add" button, add the applications to be operated on the station.
7 Repeat the steps for all other applications you want to use for the configured mode.
Tip:
You will also find this procedure in our example "OPC Configuration for
PROFIBUS"; see Section 8.
Where to we go from here?
In the next step, you supply the PC station with project engineering data.
40
How to Make the Initial Configuration without an XDB File
Result:
PC station is configured with modules and applications and ready
to receive project engineering data (select online mode)
Commissioning PC Stations - Manual and Quick Start
C79000-G8976-C156-07
Release 5/2005