Checking The Water Level - Miele G 663 Operating Instructions Manual

Solving problems

Checking the water level

If the water pressure (flow pressure at
the take-off point) is less than 1.0 bar,
too little water will flow into the wash
cabinet and the dishes will not be
cleaned properly.
To check whether sufficient water flows
into the wash cabinet:
Turn on the stopcock fully.
Run the "Pre-wash" programme
(without crockery) once to get water
flowing throughout the machine.
Start the "Pre-wash" programme
again.
After approx. three minutes open the
door and remove the bottom basket
from the machine.
58
The water level is correct when the
water level (dimension "X"), is at least
4 mm above the coarse filter in the
middle of the filter combination.
If it measures less, then either the water
inlet filter must be cleaned (see pre-
vious page) or the water intake time in-
creased (see following page).