Setting Video Capture Parameters In An Avr Session - NEC Express5800/320Ma User Manual

Managing AVR Sessions
3. To set the brightness and contrast for the three Red/Green/Blue (RGB) color
components separately, click Fine Tuning, and type values in the additional fields
that appear. Or, use the scroll bar to set the RGB components.
4. Do one of the following:
•
To apply the settings for only this AVR session, click Apply and then click
Close.
•
To use these settings for subsequent AVR sessions until you change them
again, click Save and then click Close.
Related Topics
•

"Setting Video Capture Parameters in an AVR Session"

•
"Managing AVR Sessions"
Setting Video Capture Parameters in an AVR Session
In an Advanced Video Redirection
is captured for the simulation.
To set the video capture parameters
1. Click Settings, point to Display, and click Video Capture Parameters.
2. In the Frame Rate (screen/sec) field, specify how often frames are sent to the
computer running the AVR session. The higher the value, the more often screens
are sent. The default value of zero (0) sends frames at the highest possible rate.
3. In the Compression field, select the type of compression (compression mode) to
use for the video data. Use the information in
the bandwidth between your system and the Virtual Technician Modules (VTMs),
and the performance and image quality you require. The default value is Fast
compression 1.
4-4 Express5800/320Ma: Virtual Technician Module User's Guide
N O T E
To return to the default AVR monitor settings, select
Defaults on the AVR Monitor Control Settings dialog
box, and then click Close.
N O T E
If you are using any compression scheme, do not rely on
colors for information. For example, in ftServer
Management Console (ftSMC), icons may appear
dimmed instead of bright yellow.
(AVR) session, you can control how the video data
Table 4-1 to select a mode based on