NEC Express5800 series User Manual page 85

Configure SPAN
The following explains the sample procedure to configure RAID10 (spanning of RAID1) with four
Hard Disk Drives.
IMPORTANT:
They are not supported.
1.
Click [Configuration Wizard] on WebBIOS Top Menu to start Wizard.
2.
While pressing Ctrl, click the Hard Disk Drives to be included in DG.
(In the example, two DGs will be configured and spanned.)
3.
Upon completion of selection, click [Add to Array] at the lower left of the screen. After
making sure that the new DG has been defined in Drive Groups frame to the right, click
[Accept DG].
Do not attempt to configure RAID00 or RAID60.
Configuring Your Storage and I/O Blade
4-41