9-6
Upgrading Your Storage and I/O Blade
INSTALLATION/REMOVAL PROCEDURE
Install or remove the devices in the following procedure.
Mezzanine Card
The Storage and I/O Blade can contain two mezzanine cards for blade. To install a mezzanine card,
use the mezzanine card slot installed on the CPU unit.
IMPORTANT:
The mezzanine card is extremely sensitive to static electricity. Make
sure to touch the metal frame of the Storage and I/O Blade to
discharge static electricity from your body before handling the
mezzanine card. Do not touch the terminals and parts on the
mezzanine card by a bare hand and place the cards directly on the
desk. For static notes, see the section "Anti-static Measures"
described earlier.
A combination of boards that can be installed in the Blade Enclosure
is under certain restrictions. Contact your service representative for
details.
NOTE:
boards. Refer to the manual provided with the board to check whether
the expansion ROMs should be expanded. Use the BIOS setup utility
"SETUP" for the setting. See Chapter 4 for details.
Mezzanine slot (Type I)
Mezzanine slot (Type II)
Some optional mezzanine cards use expansion ROMs on the