Installation/Removal Procedure; Mezzanine Card - NEC Express5800 Series User Manual

INSTALLATION/REMOVAL PROCEDURE

Install or remove the devices in the following procedure.

Mezzanine Card

The Tape Blade can contain two mezzanine cards for blade. To install a mezzanine card, use the
mezzanine card slot equipped on the Tape Blade.
IMPORTANT:
The mezzanine card is extremely sensitive to static electricity. Make

sure to touch the metal frame of the Tape Blade to discharge static
electricity from your body before handling the mezzanine card. Do
not touch the terminals and parts on the mezzanine card by a bare
hand and place the cards directly on the desk. For static notes, see
the section "Anti-static Measures" described earlier.
A combination of boards that can be installed in the Blade Enclosure

is under certain restrictions. Contact your service representative for
details.
NOTE:
boards. Refer to the manual provided with the board to check whether
the expansion ROMs should be expanded. Use the BIOS setup utility
"SETUP" of the CPU blade for the setting. See the User's Guide of
CPU blade for details.
Mezzanine slot (Type I)
Mezzanine slot (Type II)
Some optional mezzanine cards use expansion ROMs on the
Upgrading Your Tape Blade
9-5