Relocating/Storing The Unit - NEC Express5800 Series User Manual

RELOCATING/STORING THE UNIT

Follow the procedure below to relocate or store the Tape Blade and Blade Enclosure:
IMPORTANT:
If the Tape Blade needs to be relocated/stored due to a change in the

floor layout to a great extent, contact your service representative.
It is recommended that the Tape Blade and the internal devices

should be stored in a place where the room temperature can be
maintained. It is important for the Tape Blade or internal devices to
work normally after storage. Store the device in the place where
temperature ranges between -10 to 55°C and humidity ranges
between 20 to 80%, without dew condensation.
Do not transport the Tape Blade with the data cartridge installed.

The drive and/or the cartridge may be damaged if any shock is
given to them.
Observe the following instructions to use the Tape Blade safely. Failure to
follow these instructions may result in death or serious personal injury. See
pages 1-2 to 1-4 for details.
Do not disassemble, repair, or alter the device.

Do not remove the battery.

Disconnect the power plug before working with the device.

Observe the following instructions to use the Tape Blade safely. Failure to
follow these instructions may cause a fire, personal injury, or property
damage. See pages 1-2 to 1-4 for details.
Never attempt to lift the unit with three or less persons.

Do not install the unit in any place other than specified.

Do not connect/disconnect any interface cable with the power cord of the

unit plugged to a power source.
WARNING
CAUTION
Maintenance 7-5