Configuring The Network - Network Menu; Network Tab; Ipv4 Setting - Sony Ipela SNC-ER585 User Manual

Configuring the Network
— Network Menu
When you click Network
Network menu appears.
Use this menu to configure the network to connect the
camera and the computer.
The Network menu consists of three tabs: Network,
QoS and Dynamic IP address notification.

Network Tab

This section provides the menus for connecting the
camera through the network cable.
MAC address
Displays the MAC address of the camera.
Ethernet status
Displays the current transmission rate.
This is displayed when the network change selection
switch is set to LAN. This is not displayed when it is set
to SLOC (SNC-ZP550/ZR550).
Auto-MDI/MDIX
Automatically distinguishes the port of the Ethernet
device connected to the unit and switches the port of the
unit between MDI and MDI-X for transmission.
Displays the Ethernet port mode of the unit.
This is displayed when the network change selection
switch is set to LAN. This is not displayed when it is set
to SLOC (SNC-ZP550/ZR550).
Network type (SNC-ZP550/ZR550)
Displays the network type.
52
Configuring the Network — Network Menu
in the Administrator menu, the
SLOC appears when the network change selection
switch is set to SLOC and LAN appears when the
network change selection switch is set to LAN.

IPv4 setting

Configure the IPv4 network setting.
IP address
Configure the IP address.
Obtain an IP address automatically (DHCP): Select
this option when a DHCP server is installed on the
network to allow IP address assignment. With this
setting, the IP address is assigned automatically.
Use the following IP address: Select this option when
you set a fixed IP address. With this setting, specify
the IP address, Subnet mask and Default gateway
manually.
Note
When you select Obtain an IP address automatically
(DHCP), make sure that a DHCP server is operating on
the network.
IP address
Type the IP address of the camera.
Subnet mask
Type the subnet mask.
Default gateway
Type the default gateway.
DNS server
Configure the DNS server address.
Obtain DNS server address automatically: Select this
option to obtain the IP address of DNS server
automatically. It can be set only when Obtain an IP
address automatically (DHCP) is selected in the
Network tab.
Use the following DNS server address: Select this
when you set a fixed address as the IP address of the
DNS server. With this setting, specify the addresses
on Primary DNS server and Secondary DNS
server manually.
Note
When you select Obtain DNS server address
automatically, make sure that a DHCP server is
operating on the network.
Primary DNS server
Type the IP address of the primary DNS server.