Connecting The System To Ethernet Networks; Ports On The System - NEC Express5800/320Ma Installation Manual

Connecting the System to Ethernet Networks

2. Connect the USB cable from the keyboard to one of the system's USB ports. The
system's USB ports are interchangeable. Item 3 in
Figure 4-2
3. Connect the 15 pin D-sub connector on the VGA cable from the monitor to the
system's VGA port. Item 4 in

ports on the system.

4. Connect the VGA cable to the monitor.

Connecting the System to Ethernet Networks

1. Connect the ports for the embedded Ethernet controllers to the network. Provide
an unshielded twisted pair (UTP) cable with RJ-45 connectors for each of the four
system Ethernet ports you plan to use. Connect one end of each cable to a network
port on the system and the other end to an Ethernet wall jack or switch. Item 3 in
Figure 4-1
2. Connect the VTMs, if present, to a maintenance or other network. You need two
UTP cables with RJ-45 connectors. Connect one end of each cable to a VTM
network port. Attach the other end of each cable to an Ethernet wall jack or a
switch. Item 8 in
system.
4-4 Express5800/320Ma: System Installation Guide
shows the USB ports on the system.
Figure 4-1
and item 5 in Figure 4-2
Figure 4-1 and item 9 in
Figure 4-1
and item 6 in Figure 4-2
shows the USB ports on the systems.
Figure 4-2 shows the VTM ports on the
and item 5 in
shows the VGA