Table of Contents
Advertisement
Register a reference image
Move the cursor to "
the up and down arrow keys. Then, select "REG"
from the popup menu. The reference image that
you registered is shown in the lower right corner
of the screen.
After the setting is complete, press the ESC key
to return to the "REG COND" screen.
Note: If a reference image is not registered, you
cannot make measurements.
SEARCH ARE (MDL0)
Move the cursor to this line and press the SET key. "SET" will be highlighted. Press the SET key
again and the "RECTANGLE" screen will appear.
Use the same procedures as you used for "
of the rectangle defining the search area.
After the setting is complete, press the ESC key twice and return to the "SET WIZARD" screen.
Move the cursor to "NEXT" and press the SET key.
= In this example, the settings on the screens are not changed. Select "NEXT" on each of these
screens to go to the next screen. =
(12) Select whether or not to set the evaluation
conditions for measured results.
Select "
YES" and press the SET key.
The "DETAIL" item will appear on the lower part
of the screen. Move the cursor to "DETAIL" and
press the SET key.
REFERENCE IMG" using
REFIMG ARE(MDL0)" to adjust the size and position
STEP6
SELECT INSPECTION PRECISION
1STANDARD(PIXEL)
2HIGH(SUB-PIXEL)
RETURN NEXT
Setting the detection precision.
- For details, see page 3-20 in
Function and Operation.
7-29
Setting Examples Using the Set Wizard
RECTANGLE
RESET
RETURN
1UP. L
(224, 208)
2LO. R
(287, 271)
3MOVE
4REFFERENCE IMG
CONTRAST SRCH
REG
DISP
=MOVE ESC=BACK SEL=CHNG IMG TRG=FUNC
SET WIZARD
EXIT
[SAMPLE]
COMPARE EVALUATION
CONDITIIONS TO MEASUREMENT
RESULTS (YES/NO)
1
NO
2
YES
RETURN NEXT DETAIL
RED F C1 BRT
X:224 Y:208
COLOR F C1 BRT
TYPE00
PARALLEL+SERIAL+USB
CAPTURE IMG/PARTIAL-IMG
MEAS1/CAM1
MEAS1/F/POS DEVIAT
MEAS1/MEAS CND
MEAS1/DTECT PRECISION
MEAS1/EVALUATION
7
Advertisement
Table of Contents
