Installing, Connecting And Wiring The Iv-C35M Controller; Connecting Equipment To The Controller - Sharp IV-C35M User Manual

Connection and Installation Methods

5-2 Installing, connecting and wiring the IV-C35M controller

[1] Connecting equipment to the controller

Connect the cameras (up to 2 cameras), remote keypad, and monitor to the controller (IV-C35M).
Camera 2 connector (CAMERA2)
Camera 1 connector (CAMERA1)
Monitor connector (VIDEO)
Monitor
5
Connect the camera cable (IV-S30KC3/KC5) connector or a connector of the main interface
cable supplied with the IV-C35M to the camera 1 (CAMERA1) and camera 2 (CAMERA2)
connectors on the controller.
Note: Only connect or disconnect the camera connectors while the power is OFF.
- Push the convex side of the connector into the concave side of the mating connector. When the
connector is all the way on, it clicks.
- To disconnect the connector, hold the plug of the connector, and pull it straight out.
- A camera connected to the camera 1 connector (CAMERA1) is treated as camera 1 by this
system, and a camera connected to the camera 2 connector (CAMERA2) is treated as camera
2.
Note: You must have a camera connected to the camera 1 connector.
Plug the remote keypad (IV-S30RK1) connector into the remote keypad connector (REMOTE)
on the controller.
Connect the monitor to the monitor connector (VIDEO: RCA jack) on the controller using the
monitor cable (supplied with the controller) and a conversion connector (supplied with controller).
If the monitor has an RCA jack, the conversion connector is not required.
- Use a monitor with either an EIA or NTSC compatible video input terminal.
- Connect the cable to the monitor connector straight and treat it carefully.
- If you need a monitor cable longer than 2 m, you can purchase a one at a video store.
For details about connecting and installing cameras, see page 5-16 and after in this manual.
3
BNC connector
Monitor
Conversion
connector
RCA jack
Monitor
Remote key pad
IV-C35M
connector
(REMOTE)
Controller
(side view)
Remote keypad
2
1
Camera 2
1
Camera 1
Monitor cable
(Cable length 2 m)
5-8
4
4
Controller
Monitor connector (VIDEO)