Chapter 4: Part Names And Functions; Controller (Iv-C35M) - Sharp IV-C35M User Manual

Chapter 4: Part Names and Functions

This section describes the names and functions of the controller, camera (camera body, camera
converter, camera lens and camera cable), and the remote keypad which comprise the IV-C35M
system.
See section in Chapter 5 "Connection and Installation Methods" for details about the housing
brackets and camera angle bracket.

4-1 Controller (IV-C35M)

IV-C35M (front)
IV-C35M (side)
qMemory card connector
(with connect cover)
4 Monitor connector (VIDEO)
5 Camera 1 connector (CAMERA1)
6 Camera 2 connector (CAMERA2)
Name
I/O terminal block
INPUT: X0 to X7, C (+)
1
OUTPUT: Y0 to Y7,
READY, COM
Power terminal block
2
( 24V, 0V)
3
Power lamp (POWER)
Monitor connector
4
(VIDEO)
Camera 1 connector
5
(CAMERA1)
Camera 2 connector
6
(CAMERA2)
Communication connector
7
(RS232C/RS422: 9-pin D-
sub female, rock screw M2.6)
Remote key pad connector
8
(REMOTE)
9
Frame ground terminal
Communication connector
0
(USB)
Memory card connector
q
(COMPACTFLASH)
2 Power terminal block
1 I/O terminal block
INPUT
X0 X1 X2 X3 X4
Y0 Y1 Y2 Y3 Y4
OUTPUT
COMPACTFLASH
VIDEO CAMERA2
CAMERA1
This block has 8 input terminals and 9 output terminals.
- External devices are connected to these terminals for input and
output (parallel I/F).
Commercially available constant-voltage power supply (24 V DC
10%, 700 mA or more) is connected here.
When the power is applied to the controller, the green lamp will light.
A monitor is connected here.
- The monitor connector is an RCA female connector .
The camera cable connector is connected here.
- The camera connected to the CAMERA 1 position is camera 1,
and the camera connected to the CAMERA 2 position is camera 2.
This connector is used to connect a personal computer for communi-
cations (general purpose serial I/F) or to connect a programmable
controller for a computer link.
The remote keypad connector is used to make selections from the
menus on the screen (to set parameters). It is connected here.
Be sure to ground the housing frame ground terminal together with
the frame ground of the constant-voltage power supply in accor-
dance with class 3 grounding procedures.
This connector is used to connect a cable to a USB port on a person-
al computer.
- The USB port only functions with Windows 98/Me.
Connect a memory card (compact flash) that will be used to save
setting parameters, NG images, etc
4-1
Part Names and Functions
S
(Software version
X5 X6 X7
COM 24V
IV-C35M
Y5 Y6 Y7
READY COM 0V
POWER
3 Power lamp (POWER)
USB
REMOTE
RS232C/RS422
0 Communication
connector (USB)
8 Remote key pad connector
(REMOTE)
7 Communication connector
(RS232C/RS422)
Function
9 Frame ground
terminal
mark
4
)