Hydro Kit Accessories - LG ARNH963K2A2 Installation Manual

Table 24: LG Included Accessories
Accessory Model no.
Hydro Kit Wall Mounted
AKB73355703
Controller
1
Independent Power
Module
1
Ancillary (Solar)
MEG61846102
Heating System Tank
Indirect Hot Water
EBG61325701
Storage Tank Sensor
1,3
refrigerant Strainer MJC57132402
4
Must use LG provided communications cable (included).
1
Maximum combined current draw of all (field provided) connected accessories must be equal to or
2
less than 5 Amps @ 208-230/60/1.
Table 25: LG Optional Accessories (sold separately)
Accessory Model no.
Wired remote Exten-
PZCWRC1
sion Cable
1
Solar Heating System
Interface Kit
Ancillary (Solar)
Heating System Tank
MEG61846102
replacement
Sensor
1,2,4
remote Temperature
PQRSTA0
Sensor
dry Contact
PQDSB1
3
Must use LG provided communications cable (included).
1
Field supplied thermo paste required.
2
Maximum combined current draw of all connected accessories must be equal to or less than 5 Amps
3
@ 208-230/60/1.
Hydro Kit
Connection
Model
K2, K3 CN-REMO
CN-WRITE &
PRIP0 K2
CN-EEV
Indirect Heating
K2, K3
K2, K3 CN-TH4 (Boost) Water storage tank sensor.
K2, K3 Inlet Pipe
Hydro Kit
Connection
Model
K2, K3
PHLLA K2 CN-TH4(Solar)
K2 CN-TH4 (Solar)
K2, K3 CN-ROOM
K2, K3 CN-CC
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG Life's Good" is a registered trademark of LG Corp.

HyDro KIt accessorIes

description
Remote wall mounted controller with
33 foot communications cable.
Backup power to close EEV valve if
power failure occurs during Multi
V defrost or oil return.
Mounting for the indirect hot water
storage tank sensor complete
Tank Wall
with 39 feet of cable with plug
connector.
50 mesh; install on inlet pipe to heat
exchanger.
Must have contacts rated for 208-230/60/1.
3
1" FPT both ends
4
description
--- 39' communications extension cable.
Kit includes solar heating system
tank sensor/cable and tee fitting
sensor well.
Solar heating water storage tank
sensor with 39 feet of cable and
plug connector.
Sensor with 50' communications cable
and plug connector.
Mounts inside the unit cabinet and
provides a external binary signal
control interface.
This sensor is included when ordering the PHLLA Solar Heating Interface Kit.
4
Use
Schedules, sets operational
parameters and monitors
system.
Closes EEV if power outage occurs
during defrost or oil return.
Monitors the Hydro Kit indirect water
storage tank temperature.
Keeps large particulate from entering
the heat exchanger.
Use
Extends the length of the Hydro
Kit Wall Mounted Controller
communications cable beyond
39 feet (cannot be used to
extend tank sensor cable
length).
Monitors a third party solar
heating system's water circuit
temperature and controls the
flow of solar heating system
water to the indirect water
storage tank.
Monitors the solar heating system
water circuit temperature.
Monitors and/or controls (optional)
the Hydro Kit based on the
conditioned space temperature.
Enables/disables operation from a
remote generated binary signal.
73