Prepare The Venting; Before You Start; Remove The Mounting Plate; Installation Tgpes - GE JVM2052 Installation Instructions Manual

Installation Instructions
[_ PREPARE THE VENTING
AWARNING:
• To avoid the risk of property damage, unplug the
microwave oven or disconnect power at the source
by removing the fuse or throwing the circuit breaker.
• To avoid the risk of personal injury, wear protective
gloves when handling the mounting plate.
• DO NOT PULLOR STRETCH THE BLOWERWIRING!
Pulling and stretching the blower wiring could result
in electrical shock.
NOTE:Your microwave oven is shipped with the blower
assembled for room venting. If you want wall-vented
or roof-vented installation, you must change the blower,
as detailed below.
F_ BEFORE
YOU START
[] Remove any shipping materials and parts from
inside the microwave oven.
[]
Cover the counter top or cooktop with a thick,
protective covering to protect it from damage
and dirt.
A thick,protective
covering
NOTE: If you have a free-standing range, disconnect
it, move it onto a piece of cardboard or hardboard
and pull it away from the wall. This allows you to
get closer to the upper cabinet and back wall for
easier measuring and drilling.
r_ REMOVE THE MOUNTING PLATE
Remove the mounting plate screw(s)(1 or 2 screws)
from the mounting plate as shown and discard.
Mounting
plate
Mounting plate Mounting plate screw(s)
screw(s) (1 or2 Mounting plate (1 or2
ontro,/
pane I'..Jql l I!1 1
side . ' : Control ---
_,-- _
.... panel /
%
%
%
This plate will be used as the rear mounting plate.
(It will be used to locate and mark the mounting
holes on the rear wall.
Locate the exhaust adapter, grease filters and
hardware packet.
At this point, remove any adhesive tape (if there is
any), on the exhaust adapter, the grease filters and
the power supply cord.
I_ INSTALLATION TYPES
Room-Vented (recirculating)Installation:
This oven is shipped assembled for room venting.
Wall-Vented Installation:
%
Remove one blower unit mounting screw and one
or two blower plate screw(s). Remove the blower
plate from the cabinet.
_______-- Blower p late
_!............. i Mounting screw
i.......... ! _"_J (option)
__ Blower p late
Blower u nit _ Back plate
_ _-_y_b_h II _!_ ' Blowe[unit
y-'.__ mounting screw
Parts "B" (option)
%
%
Carefully lift the blower unit out of the microwave
oven.
Use side cutters or tin snips to cut and remove
knockouts "B" from back plate. Discard the
knockouts. Be careful not to distort the plate.
Knocl<outs P arts"B"
10