Installation
Instructions
TOOLS YOU WILL NEED
Phillipsscrewdriver
Flatbladescrewdriver
Ruleror tapemeasure
aightedge
Carpentersquare
(optional)
Tin snips(for cutting
damper,if required)
Gloves
Safety goggles
Pencil
Scissors
(to cut template, if necessary)
@===_
Saw(saber, holeor keyhole)
Electricdrill with 3A" and 3¼,, wood
drill bits and34¢and _½" drill bits
8
Studfinder or
Hammer(optional)
Clear tape
(for taping the templates to the wall)
Plumb line
4P"
Caulking gun
Duct and masking tape
MOUNTING SPACE
II i
Ill III I
UJJ
Bottom edgeof
NOTE: Maximum cabinet d epthis 13". _
cabinet n eeds to
be30"or more
-- E---"
fromthecooking
surface
66" or more
from the floor
to the top of
the oven
Bacl<splash
NOTES:
• The space between the cabinets must be ]0" wide
and free of obstructions.
• If the space between the cabinets is greater
than ]0", a Filler Panel Kit mag be used to fill
in the gap between the oven and the cabinets.
Your Owner's Manual contains the kit number
for gour model.
• This oven is for installation over ranges up to
36" wide.
• If gou are going to vent gour oven to the outside,
see Hood Exhaust Section for exhaust duct
preparation.
• When installing the oven beneath smooth, flat
cabinets, be careful to follow the instructions
on the upper cabinet template for power cord
clearance.
• Maximum cabinet depth above and beside
the unit is !]".
• For models with top venting holes: Do not allow
cabinetrg or other objects to block the airflow
of the vent.