Install The Mounting Plate - GE JVM2052 Installation Instructions Manual

Installation Instructions
INSTALL THE MOUNTING
PLATE (cont.}
Minimum
66"from
the floor
3/16" Holeon studs
5/8" hole on drywall only
Ill Forwa,l-"
_ on'y
' / Drawlines '
/ Mounting plate on studs ',
/ /' / " _ Drawcenter l ine
Center l ine
J
Support tab Support tab
For Well-Vented
• Make the box cutout for the rear wall duct.
i piece mounting plate:
Using a pencil, put dots through slots F and G, and
through holes H and I. Remove the mounting plate
and draw lines extending through the points. This will
give the location and size of the box cutout for the
rear wall duct.
3 pieces mounting plate:
Use the wall template to determine the location and
size of the box cutout for the rear wall duct.
Attach the exhaust adapter to the rear mounting
plate (backplate) wall side. Push in securelg until it is
past the top locking tabs and in the lower locking
tabs. Take care to assure the damper hinge is
installed so that it is at the top and that the damper
swings freelg.
Before using the screws to attach the plate to
the wall: Carefullg guide the exhaust adapter, now
attached to the mounting plate, into the house duct.
This will assure proper alignment for installation.
Return to step 5, item 5 to continue. After completing
the installation of the mounting plate, again check
the rear damper for free movement to assure it will
operate properlg.
Exhaust a dapter Damper
(hingeside up)
Slide
exhaust
adapterinto
guideson
rearpanel.
Guide
Mounting plate
(1 piece mounting
plate)
Backplate 1 piece
mountingplate
(3 pieces
mountingplate)
Lockingtabs
Guide
14