Important Safety Instructions; Electrical Requirements - GE JVM2052 Installation Instructions Manual

Installation Instructions
IMPORTANT SAFETY INSTRUCTIONS
This product requires a three-prong grounded outlet.
The installer must perform a ground continuitg check
on the power outlet box before beginning the
installation to insure that the outlet box is properlg
grounded. If not properlg grounded, or if the outlet
box does not meet electrical requirements noted
(under ELECTRICAL REQUIREMENTS), a qualified
electrician should be emploged to correct ang deficiencies.
I}}/I -&CAUTION:
i For personal safetg, remove
house fuse or open circuit
breaker before beginning
installation to avoid severe
or fatal shock injurg.
-& CAUTION:
For personal safetg, the mounting
surface must be capable of supporting the cabinet load,
in addition to the added weight of this 63-85 pound
product, plus additional oven loads of up to 50 pounds
or a total weight of 113-135 pounds.
-A CAUTION: For personal safetg, this p roduct
cannot be installed in cabinet arrangements suchas an island
or a peninsula. It must be mounted to BOTH a top cabinet
AND a wall.
NOTE: For easier installation and personal safetg,
it is recommended that two people install this product.
IMPORTANT--PLEASE READ CAREFULLY.
FOR PERSONAL SAFETY,THIS APPLIANCE MUST
BE PROPERLY GROUNDED TO AVOID SEVERE
OR FATAL SHOCK.
Insureproper
groundexists
before use
The power cord of this
appliance is equipped with
a three-prong (grounding)
plug which mates with
a standard three-prong
(grounding} wall receptacle
to minimize the possibilitg
of electric shock hazard
from this appliance.
You should have the wall receptacle and circuit checked
bg a qualified electrician to make sure the receptacle is
properlg grounded.
Where a standard two-prong wall receptacle is
encountered, it is verg important to have it replaced
with a properlg grounded three-prong wall receptacle,
installed bg a qualified electrician.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT, DEFORM OR
REMOVE ANY OF THE PRONGS FROM THE POWER CORD.
DO NOT USE WITH AN EXTENSION CORD.
ELECTRICAL
REQUIREMENTS
Product rating is 120 volts ACE,60 Hertz, 14.5 amps
and !.70 kilowatts. This product must be connected
to a supplg circuit of the proper voltage and frequencg.
Wire size must conform to the requirements of the National
ElectricalCode or the prevailing local code for this kilowatt
rating. The power supplg cord and plug should be brought
to a separate !5 to 20 ampere branch circuit single
grounded outlet. The outlet box should be located in the
cabinet above the oven. The outlet box and supplg circuit
should be installed bg a qualified electrician and conform
to the National Electrical Codeor the prevailing local code.
3