Battery Replacement; Turning The Power On/Off; Setting The Date And Time - Panasonic KX-TCD210G Operating Instructions Manual

TCD210G(e-g).book Page 10 Friday, January 14, 2005 1:42 PM
Preparation
Battery life
After your Panasonic batteries are fully charged,
you can expect the following performance:
Ni-MH batteries (700 mAh)
Operation
While in use (talking)
While not in use
(standby)
Hinweis:
L Actual battery performance depends on a
combination of how often the handset is in use
(talking) and how often it is not in use
(standby).
L Battery operating time may be shortened over
time depending on usage conditions and
ambient temperature.

Battery replacement

If 7 flashes even after the handset batteries
have been charged for 7 hours, the batteries
must be replaced.
Wichtig:
L We recommend the use of Panasonic
rechargeable batteries noted on Seite 5. If you
install non-rechargeable batteries and start
charging, the batteries may leak electrolyte.
L Do not mix old and new batteries.
1
Press the notch on the handset cover firmly
and slide it in the direction of the arrow.
2
Remove the old batteries positive (S)
terminal first and install the new ones. See
Seite 9 for battery installation.
10

Turning the power on/off

Power on
Press {ih} for about 1 second.
Operating time
L The display will change to the standby mode.
20 hours max.
Power off
170 hours max.
Press {ih} for about 2 seconds.
L The display will go blank.

Setting the date and time

Wichtig:
L Confirm that the AC adaptor is connected.
L Ensure that w is not flashing.
1
2
3
4
5
6
7
8
Hinweis:
L To correct a digit, press {<} or {>} to move
L The date and time may be incorrect after a
Press {j/OK}.
Select "Mobilteileinst.", then press
{>}.
Select "Zeiteinstell.", then press {>}.
Select "Datum/Uhr eing.", then press
{>}.
Enter the current day, month and year by
selecting 2 digits for each.
Beispiel: 17 May, 2005
Press {1}{7} {0}{5} {0}{5}.
Enter the current hour and minute by
selecting 2 digits for each.
L You can select "AM", "PM" or 24-hour time
entry by pressing {*} repeatedly.
Beispiel: 3:30 PM
Press {0}{3} {3}{0}, then press {*}
repeatedly until "03:30 PM" is displayed.
Press {j/OK}.
Press {ih}.
the cursor, then make the correction.
power failure. In this case, set the date and
time again.