Panasonic KX-TCD210G Operating Instructions Manual page 25

TCD210G(e-g).book Page 25 Friday, January 14, 2005 1:42 PM
L If the location already contains a carrier
code, the code is displayed.
9
Enter the carrier code (7 digits max.), then
press {j/OK}.
10
Press {ih}.
Storing area codes for ARS
Store the area codes which should be dialled
using a specific carrier. You can store up to 25
area codes.
1
Press {j/OK}.
2
Select "Basis-Einstell.", then press
{>}.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (Seite 26).
4
Select "Rufoptionen", then press {>}.
5
Select "Tarifmanager", then press {>}.
6
Select "Vorwahlnr.", then press {>}.
7
Select an area code location (1 to 25), then
press {>}.
L If the location already contains an area
code, the code is displayed.
8
Enter an area code (5 digits max.), then
press {j/OK}.
9
Select a carrier code you stored (C1 to C5)
earlier, then press {>}.
L This carrier code will be automatically
dialled when you make a call to this area
code.
10
Press {ih}.
Turning ARS off
1
Press {j/OK}.
2
Select "Basis-Einstell.", then press
{>}.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (Seite 26).
4
Select "Rufoptionen", then press {>}.
5
Select "Tarifmanager", then press {>}.
6
Select "Netzbetreiber", then press {>}.
7
Select "Aus", then press {>}.
8
Press {ih}.
Base Unit Settings
Setting call restriction
You can restrict selected handsets from dialling
certain numbers. You can assign up to 6 phone
numbers to be restricted, and select which
handsets will be restricted. Storing area codes
here will prevent the restricted handsets from
dialling any phone number in that area code. If a
restricted number is dialled, the call will not be
connected and the restricted number will flash on
the display.
1
Press {j/OK}.
2
Select "Basis-Einstell.", then press
{>}.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (Seite 26).
4
Select "Rufoptionen", then press {>}.
5
Select "Wahlsperre", then press {>}.
6
Set which handsets will be restricted by
pressing the desired handset number.
L All the registered handset numbers will be
displayed.
L Flashing numbers indicate call restriction
is turned on for the corresponding handset.
L To turn call restriction off for a handset,
press the number again. The number will
stop flashing.
7
Press {j/OK}.
8
Select a memory location, then press {>}.
L If the memory location already contains a
restricted number, the number is
displayed.
9
Enter the phone number or area code to be
restricted (8 digits max.), then press
{j/OK}.
L To erase a restricted number, press
{C/T}.
10
Press {ih}.
25