Table of Contents
Advertisement
2. Preparation
Note:
L You can confirm if the unit is connected to your
computer on Device Monitor (page 67).
L Computer features (printing, scanning, etc.) may not
function properly in the following situations:
– When the unit is connected to a computer that
was custom-built by the user.
– When the unit is connected to the computer via a
PCI card or other expansion card.
– When the unit is connected to another piece of
hardware (such as a USB hub or interface
adapter) and not connected directly to the
computer.
To change the settings
You can change the settings for Multi-Function Station
beforehand.
1. Select [Settings] from Multi-Function Station.
2. Click the desired tab and change the settings. i
[OK]
[General]
– Launcher display: To select the display type of the
launcher.
– OCR Path: To select the OCR software.
– PC name list up (LAN connection only): To select
whether or not your computer name is displayed on
the unit.
– PC name (LAN connection only): The computer
name that will be displayed on the unit.
[Scan]
– Save to: To select the folder where the scanned
image will be saved.
– Viewer/File/E-Mail/OCR/Custom: To change
scanning settings for Multi-Function scan
application.
Note:
L Assign a unique name for the [PC name] to avoid
overlapping, or the scanned image may be sent to an
undesired computer.
To select the default E-mail software
The default E-mail software is used when using
"4.1.3 Scan to E-mail", page 29.
You can select the default E-mail software as follows.
For Windows XP:
1. [Start] i [Control Panel] i [Internet
Options] i [Programs] i [E-mail]
2. Select the desired MAPI-compliant E-mail software
such as [Outlook Express], etc. i [OK]
L These steps may vary depending on your operating
system.
24
Advertisement
Table of Contents
