Table of Contents
Advertisement
Customizing Projector Features
Use the settings in this section to adjust the image size and position, suppress on-screen text,
and select basic setup options.
Image Sizing
Before adjusting any of these settings, make sure you have already selected an appropriate
aspect ratio for the type of picture you're viewing (see page 26).
■ Overscan
Signal > Advanced > Overscan
Note: This option may not be available depending on the video device connected to the
projector.
For component and HDMI video formats, this setting lets you see the edges of the image
that are not normally visible in the picture (see page 77). If you see interference when you
set
to
Overscan
Note: The Auto setting is only available when the input source is HDMI1 or HDMI2.
■ Position
Signal > Position
Note: This setting cannot be used with a signal input through the HDMI1 or HMDI2 port.
Use the arrow buttons to fine-tune the position of the image on the screen.
■
Aspect
Signal > Aspect
This setting lets you change the aspect ratio of your image, and works the same as
pressing the
Aspect
Note: When displaying 720p, 1080i, or 1080p signals through the HDMI or Component video
port, the aspect ratio is automatically selected by the source device and you cannot change it.
If you display a 4:3 image using the Zoom setting, the top and bottom will be cut off. You can
use the Zoom Caption Pos. option and other settings to resize and reposition the image.
For details on how the projector resizes the picture when you choose an Aspect setting, see
page 77.
, try adjusting the
Off
button on the remote control. See page 26 for more information.
as described below.
Position
Making Detailed Adjustments
51
Advertisement
Table of Contents
