Setting The Configuration; Enter The Administrator Mode; Enter The Configuration Edit Mode (Begin Editing The Configuration) - Hitachi GR2000-B Series Quick Start Manual

3.3

Setting the Configuration

This section explains about how to configure the GR2000-B for operation.
Here is some detailed information about the each of the settings.
3.3.1

Enter the Administrator Mode

!
3.3.2

Enter the Configuration Edit Mode (Begin Editing the Configuration)

!
GR2K-GA-0008
Rev. 1.00
(1) The system enters the administrator mode.
(2) The system enters the configuration edit mode.
(3) The configuration file is opened.
(4) IP address is set for the Ethernet port.
(5) A default route is set.
(6) The information configured is dispayed.
The information displayed as a
result of the configuration.
(7) The configuration information is saved.
(8) The configuration file is closed.
(9) The system goes out of the configuration edit mode.
(10) The system goes out of the administrator mode.
The system is switched to the
administrator mode by the
enable command.
The # prompt is used in the
administrator mode.
The system is switched to the
configuration edit mode by the
configure command.
The (config)# prompt is shown.
Basic Operations
3-3