Table of Contents
Advertisement
OPERATING INSTRUCTIONS (continued)
SETUP MENU (Video mode)
Selected characters
System
Color System
AV1~AV5
Video Input
AV1, AV2
RGB1
RGB2 (1st step)
RGB2 (2nd step)
System1
System2
Setup hint
Do not change the original setting.
(System1: Europe/Asia, System2: North America)
This should correspond to the color system of the signal from the
equipment that is connected to AV1~AV5 video input terminal.
• Normally, set this to Auto. The system of the input signal will be
automatically recognized.
• If the input signal contains much noise or has a low level at Auto and
the operation is found erratic, set this to match the input signal.
• When the component signal is received, this would be not available
(grayed out).
This should correspond to the signal mode of the signal from the
equipment that is connected to AV1, AV2 video input terminal.
• Normally, set this to Auto. The signal mode of the input signal will be
automatically recognized.
• If the input signal contains much noise or has a low level at Auto and
the operation is found erratic, set this to match the input signal.
This should correspond to the signal mode of the signal from the
equipment that is connected to RGB1 DVI terminal.
This should correspond to the signal mode of the signal from the
equipment that is connected to RGB2 D-sub terminal.
This step should be set only when [Component] is selected on the 1st
step.
This should correspond to the signal mode of the signal from the
equipment that is connected to RGB2 D-sub terminal.
• Normally, set this to Auto. The signal mode of the input signal will be
automatically recognized.
• If the input signal contains much noise or has a low level at Auto and
the operation is found erratic, set this to match the input signal.
31
Advertisement
Table of Contents
