Chapter 4. Srv. Reset And Master Reset - Sharp UP-600 Service Manual

CHAPTER 4. SRV. RESET AND MASTER RESET

The SRV key is used for operating in the SRV mode.
1. SRV. RESET (Program Loop Reset)
Procedure
•
Method 1
1) Turn off the AC switch.
2) Set the mode switch to (SRV') position.
3) Turn on the AC switch.
4) Turn to (SRV) position from (SRV') position.
•
Method 2
1) Set the mode switch to PGM2 position.
2) Turn off the AC switch.
3) While holding down the JOURNAL FEED and RECEIPT FEED
keys, turn on the AC switch.
Note: When disassembling and reassembling always power up us-
ing method 1 only. Method 2 will not reset the CKDC9.
Note: SRV programming job#926-B must be set to a "4" to allow the
PGM program loop reset.
PRG. RESET
2. MASTER RESET (All memory clear)
There are three possible methods to perform a master reset.
MRS-1 (Master resetting 1)
Used to clear all memory contents and return the machine back to its
initial settings.
Returns the keyboard to the default layout.
Procedure
1) Turn off the AC switch.
2) Set the MODE switch to the (SRV') position.
3) Turn on the AC switch.
4) While holding down the JOURNAL FEED key, turn to the
(SRV) position from the (SRV') position.
MRS-2 (Master resetting 2)
Used to clear all memory and keyboard contents.
This reset returns all programming back to defaults. The keyboard
must be entered by hand.
This reset is used if an application needs a different keyboard layout
other than that supplied by a normal MRS-1.
Procedure
1) Turn off the AC switch.
2) Set the MODE switch to the (SRV') position.
3) Turn on the AC switch.
4) While holding down the JOURNAL FEED and RECEIPT FEED
keys, turn to the (SRV) position from the (SRV') position.
5) Key position assignment:
After the execution of a MRS-2, only the RECEIPT FEED and
JOURNAL FEED keys can remain effective on key assignment.
Any key can be assigned on any key position on the main key-
board.
[key setup procedure]
MRS-2 executed 0 Key position set
MASTER RESET
NOTES:
*1: When the 0 key is pressed, the key of the key number on the
display is disabled.
*2: Push the key on the position to be assigned. With this, the key of
the key number on the display is assigned to that key position.
*3: When relocating the keyboard, the PGM 1/2 modes use the
standard key layout.
Key Key Key
No. name No.
001 011
002 012
003 013
004 014
005 015
006 016
007 017
008 018
009 019
010 020
*2
Free key Free key setup
complete.
*1
0
Disable
Key Key Key
name No. name
021
022
023