Speaker Setup - Kenwood DNX7140 Instruction Manual

Setup Menu
DSP Bypass Control
Temporarily bypassing DSP (Digital Signal
Processor) System.
D
Display the Audio SETUP screen
Touch [Gt]
>
[~]
>
[Audio SETUP]. (page
63)
II
Set the DSP Select
[Bypass] There is no effect by DSP
[Through] There is an effect by DSP
~
~
• When the mode is set to [Bypass], DSP System cannot
be adjusted.
Speaker Setup
You can select a speaker type and its size to get
the best sound effects.
D
Display the Speaker Select screen
Touch [Gt]
>
[~]
>
[Audio SETUP]
>
[Speaker Select]. (page 63)
II
Select a speaker you wish to adjust
When the speaker type and size are set, the
speaker crossover network and equalizer curve
are set automatically.
OJ
Front speaker
!lJ
Rear speaker
[l] Su bwoofer
[Tweeter] You can set the tweeter when you
are selecting front speakers.
If you are using a tweeter together with the
78 DNX7140/DNX7000EX/DDX714/DDX7034BT
front speakers, set the tweeter to "ON". In the
"ON" position, the Equalizer is adjusted to its
best position.
[X'over] Displays the Speaker Crossover Setup
screen.
You can adjust the crossover setup that was
set automatically when you selected the
speaker type.
D
Select a speaker type
You can select any of the following speaker
types.
"Front" OEM,4 inch, 5 inch, 6-112 inch, 6-3/4
inch,7 inch,4x6,5x7,6x8,6x9, 7x10
"Rear" NONE, OEM, 4 inch, 5 inch, 6-1/2 inch,
6-3/4 inch, 7 inch,4x6,5x7,6x8,6x9, 7x10
"Subwoofer" NONE,6 1/2 inch, 8 inch, 10 inch,
12 inch, 15 inch over
Q
~
• Select "NONE" if you have no speakers.
Crossover Network Setup
You can set a crossover frequency of speakers.
D
Select the speaker to set the crossover
[I]
Sets the High Pass Filter of the front speaker.
[lJ Sets the High Pass Filter of the rear speaker.
W
Sets the Low Pass Filter of the sub woofer.
II
Display the Crossover setup screen
.......... } ( o v e r " : ; ; ;
~
,... Ridgeview
R ~ 99999-,gg-~