Battery Installation; Remote Controller Mode Switch - Kenwood DNX7140 Instruction Manual

~'i;!1!11!!;' .,;;i11y~t?:~;
"I..,ifoPj- . . . . ' ...
11i~;f-
~;i:i1!£1?"-
.. . . . . ; i!.;!!ff'
~;IA!I"f*fl ~,~/"f'-I.I
. . . . ;....-;.!..-1' , ,.;'...
;1...,.';1
~ote Con~#~'r
.1,-:''','
1~;I
... · :"
~i!.7:!.~:' "~1'
I~;.!.~t-f'
#!j~;;"
~;;' For DNX7140/ DNX7000EX/ DDX7034BT : This unit can be operated using the Remote Controller supplied
with this unit.
For DDX714: Optional Remote Controller KNA-RCDV330 is designed for controlling this unit.
&
Put the Remote Controller in a place where it will not move during braking or other operations. A dangerous situation could
result, if the Remote Controller falls down and gets wedged under the pedals while driving.
Do not place the battery near an open flame or heat source. This may cause the battery to explode.
Do not recharge. short, break up or heat the battery or place it in an open fire. Such actions may cause the battery to leak
fluid. If spilled fluid comes in contact with your eyes or on clothing, immediately rinse with water and consult a physician.
Place the battery out of reach of children. In the unlikely event that a child swallows the battery, immediately consult a
physician.
ACAUTION
• Do not leave the battery near fire or under direct sunlight. A fire, explosion or excessive heat generation may result.
Battery installation
Use two IAAA I I"R03"-size batteries.
Insert the batteries with the
+
and - poles aligned
properly, following the illustration inside the case.
Remote Controller mode switch
The functions operated from the remote
controller differ depending on the position of the
mode switch.
-~-_._;:;;---...,
(3
8
8808:
~
~
AUOl
~
OVO.
TV~
NAVIJ
1
If the Remote Controller operates only over shorter
distances or does not operate at all, it is possible that
the batteries are depleted. In such instances, replace the
both batteries with new ones.
AUDmode
Switch to this mode when controlling a selected
source or tuner source, etc.
DVDmode
Switch to this mode when playing DVDs or CDs etc.
with the player integrated in this unit.
TV mode
Switch to this mode when controlling TV.
NAVI mode
Switch to this mode when controlling the
Navigation unit.
~
The position of the remote control mode switch is
indicated in the title of each mode, e.g., "(AUD mode)".
When controlling a player that is not integrated in the
unit, select "AUD" mode
English 87