Setup Procedures - NEC N8800-155F User Manual

4-18 Windows Setup

Setup Procedures

Express Setup precedes the setup by selecting or inputting several parameters on the wizard.
You can also save the parameters to a floppy disk as a Parameters file.
IMPORTANT:
■ The Scalable Networking Pack (SNP) function is disabled in the system that is installed
by Express Setup.
The setting of SNP function may affect the system performance, so please refer to the
attention of SNP detail in the following site before setting it.
http://www.nec.com/global/prod/express/
CHECK:
To execute Express Setup with a Parameters file, one empty 1.44MB formatted floppy disk
is required. Prepare an empty floppy disk in advance.
When you reinstall OS, you can skip entering the parameter in the Wizard form, by reading
the Parameters file that has been saved.
1. Turn the power of peripheral device on, and then turn on the server.
2. Insert the NEC EXPRESSBUILDER DVD into the optical disk drive of the server.
3. Press the RESET switch or press Ctrl, Alt, and Delete to reboot from the NEC
EXPRESSBUILDER. (You may also turn off and then on again to reboot the server.)
The system will boot from the
DVD and NEC
EXPRESSBUILDER starts.
Select "Os installation" from the
Boot selection menu. (After selecting
"Yes" on the confirmation screen,
the dialog of procedure 4 is
displayed.)