Table of Contents
Advertisement
General
Subnet Mask: The default is 255.255.255.0. All devices in the network must share the same subnet mask.
Default Gateway: The default is 192.168.1.1. Enter the gateway IP address for the network, typically a router.
SNTP/NTP: The time server IP address, time zone, and the local time will be displayed.
Time Zone: Select your time zone from the drop-down menu.
Server IP: Enter the IP address of a SNTP/NTP server.
Daylight Saving Time: Check the box to enable daylight saving time.
SNMP
Public Community: When enabled, change the Public Community Name here.
Private Community: When enabled, change the Private Community Name here.
Syslog
System Activity: Select "Enable" to allow the logging of system actions, such as logging a firmware
upgrade.
Wireless Activity: Select "Enable" to allow the logging of any wireless clients that connect to the AP.
Notice: Select "Enable" to allow all other information to be logged.
Remote Syslog Server: If you require more space to hold your logs, please provide the IP address of the
Server. The embedded memory can only have up to 300 logs.
SMTP
SMTP Server IP: IP address of SMTP Server
SMTP Sender: The sender's Email address
SMTP Recipient: The receiver's Email address
Wireless
802.11a Basic Settings / 802.11g Basic Settings:
Super Mode A/G Mode: Select either Disabled, Super A without Turbo, Super G without Turbo or
Super G with Dynamic Turbo. When Multi-SSID is selected as enabled, the item Super Mode cannot be
active. Super G Mode can only be changed when Multi-SSID is disabled.
Disabled: Standard 802.11a/g support, no enhanced capability.
o
Super A/G without Turbo: Capable of Packet Bursting, FastFrames, Compression, and no Turbo
o
mode.
Super G with Dynamic Turbo: Dynamic Turbo Mode is only enabled when all devices on the wireless
o
DSA-6100 User Guide
72
Advertisement
Table of Contents
